Both Antiphonal organ wind chests are now in place.

Start of the wind chest base in the east lower chamber.

Laying of the floor frame on the west side of the altar.
Note the cutouts for the various heating and wind ducts.

The first 2 air handlers in the east lower chamber.

Bringing the "Genie" lift purchased for use in the CLC
up into the chancel for use in the organ installation.

Air regulator and wind line in the east Antiphonal
organ chamber (in the balcony).

Reinstalling the "bottom boards" in the west Antiphonal chamber.

Installing the structural members for the wind chest on the west side of the altar.

Additional structural members in the east lower chamber.

Installing structural member for the wind chest on the east side of the altar.

The first and longest pipes after installation
on the west side of the altar.

The east side pipes and air regulators awaiting installation.

The underside or bottom board side of the first wind chest installed in the east chamber.

The second wind chest in the east chamber.

Frank and Glenn positioning the redesigned cross on the face of the altar for review by our select positioning committee. The cross was originally much smaller and sat directly on the altar. We had the original cross mounted on a larger cross with very simple lines. This redesigned cross will be more visible and will be mounted on the face of the altar.

Screwing in the lag bolt that will hold the cross into the altar face.

The initial mounting.